2016年4月28日星期四

BMW Remote Control Setting to copy and use

BMW since 1995 with programmable automatically setting the remote control whenever the owners to the door when, automatically change the frequency signal to increase the insurance function, takes more than a minute or so every time you replacethe remote control batteries after removing battery, remote control need reset program, this program can also be used to copy the remote control.
A set program and replication, remote control

1. you must first disarm alarm mode to reset the remote control and replication
2. determine battery good all doors, hood, trunk lid is closed
3. plug the key into the ignition switch, and go to the ACC,5 to OFF within seconds.
4. press and hold the key button "a", while in 10 seconds press "b" three times and then release the "a" button
5. the Central doors lock again to unlock, set completed.
6. If you want to copy the new remote control, it must 
be calculated in step 4 complete in 30 seconds all the settings

















Second, BMW car key remote control instructions

1, the remote control keys on the receiver in the vehicle (in-car rearview mirror), valid for approximately 10 meters
2, unlocked by pressing the "b" key: the LED is lit on the key before turning off, door lock system to lift
Press the "b" key and hold: anti-theft system release
Lock 3, press the "a" button once: the LED on the key light goes out after and lock system and anti-theft system
4, lock not start after alarm press the "a" 3 times, LED is lit before turning off, and vehicles can be moved, towed, propped up
When he was three, battery when the battery-free radio, opened carriage door needto proceed as follows: the car keys to the driver's side door, 30-45 degrees clockwise, then the door handle, then rotate 90 degrees to open the door. Doors open whenthe open method

KLOM Cordless Electric Auto Pick Gun Instructions for use

The gun rakes open pin and disc tumblir cylinders using a rapid up and bottom pins to separate,meeting the shear line.
The up and down motion is adjustable by a thumbscrew with a locking mut controlling the action after the range of motion is set.











Comes complete with a 110-220V AC charger, 18 picking accessories and 2 tension head.
Also comes with a strong protective carry case, and a mini adaptor according to your country. (EU power plug default)

If you are interested can click on: KLOM Electric Pick Gun

Toyota and Lexus Key Specialists Toyota Key Programming

TYPE1
TOYOTA
4Runner 1999 2000 2001
Avalon 1998 1999 2000 2001 2002 2003 2004
Camry 1998 1999 2000 2001 2002
Highlander 2001 2002 2003
Land Cruiser 1998 1999 2000 2001 2002
MR2 2000 2001 2002 2003 2004 2005
Sienna 1999 2000 2001 2002 2003
Sequoia 2001 2002
Solara 1999 2000 2001 2002 2003
1. Insert an already programmed master key into the ignition. Do not turn.
2. Press and release the gas pedal 5 times.
3. Press and release the brake pedal 6 times.
4. Remove the key from the ignition.
5. Insert the new key you want to program into the ignition.
6. Press and release the gas pedal one time.
7. Wait 1 minute. The security light will be blinking for this one minute. When it stops blinking your
key is programmed. To end programming step on brake one time.
NOTE: Look for your security light. This light will guide you during the programming procedure. The security light will go off at Step 1. It will remain off until Step 6. The security light will come on and start to blink after Step 6 until the key is programmed. If the security light comes on after Step 4 STOP the procedure and start over again.
If you perform this procedure too slowly your car will not go into programming mode. If you can not get your car to go into programming mode make sure you are using a master key and not a valet key. If you have a master key then you will probably need to perform this procedure more quickly.

TYPE 2
TOYOTA
Prius 2001 2002 2003
Sequoia 2003 2004 2005
1. Close all doors.
2. Insert an already programmed master key into the ignition.
3. Turn the key from the OFF to On and back OFF FIVE (5) times.
4. Open and close the drivers door SIX (6) times.
5. Remove the key from the ignition.
6. Insert the new key you want to program into the ignition.
7. Turn the key to the ON position.
8. Wait 2 minutes. The security light will be blinking for this one minute. When it stops blinking your key is programmed.
9. Remove your key
10. Open and close the drivers door 1 time.
NOTE: You have 35 seconds to complete steps 1-5 and 10 seconds to complete step 7. If you do not do this procedure fast enough the car will not go into programming mode and your key will not program.
If the security light does not go out after 2 minutes start the procedure over again.
TYPE 3
TOYOTA
4Runner 2003 2004 2005
Avalon 2005
Camry 2004 2005 2006 2007
Corolla 2005
Highlander 2004 2005
Land Cruiser 2003 2004 2005
Prius 2004
Sienna 2004
Solara 2004
Tacoma 2005
You can not program in this key yourself.
You need to take your car and your key to either the dealer or to a local locksmith that has the Toyota key programming software.

How to Use HUK Locksmith Hammer Bit Set

Rubber hammer
In your work without sound, or the sound is very light.
You don't have to worry about noise impact to your customers.














Method of use:
1. before using WD40 in the lock, the lock cylinder push rod is inserted into rock,debris removal, no elastic spring elasticity.
2. drive spring slight twist, torque cannot be forced, if power is great, it makes marbles lock cannot be beat.
3.2 Pearl place rubber band adjustment.
4. Insert the lock cylinder back and forth pull, if not prevented, location of the beadsis right.
5. the hammer striking the surface, and time is short.
6. tap position to maintain when horizontal lines.
Note: if you have a step not, the effect will be bad.
Due to the translation, part defect, please understand.

 Click on the lockwish

Cloupor MINI 50W + Aspire atomizer Evaluation

Has recently been heard friends introduce the benefits of electronic cigarettesand taste. So I tried to buy an electronic cigarette and E-liquid.
I have been searching the Internet the relevant information, and according to the evaluation we chose: Cloupor MINI 50W and Aspire atomizer.













E-, PRIME 15, Boreaux coffee. mango 888
First electronic cigarette, I feel is sweet and refreshing. Perhaps because I smoke mango-888, which is a Malaysia E-liquid. Tastes tend to cool and tropical styles.
I love this machine. The first time I used it to select 15W, core-but it is easy to burnyour spray.
I had to adjust to 10W, and choose the smallest hole. The fog is very small, not as big as many e-cigarette smoke, but I love the taste, people put it down. I believe thisproduct is the electronic cigarette even tastes the best. And it has a satisfactory price.